Jump to content
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble

MSFN is made available via donations, subscriptions and advertising revenue. The use of ad-blocking software hurts the site. Please disable ad-blocking software or set an exception for MSFN. Alternatively, register and become a site sponsor/subscriber and ads will be disabled automatically. 


Sign in to follow this  
soulkeeper

Problem after installation.

Recommended Posts

Add me to this club.

Using the EXACT same settings, all is fine with RC8, but with 1.0f - endless loop of BSOD and restart on final reboot.

ICH5 seems to be one of the common denominators as I see it listed several times here and I am running Raptors in RAID 0 on an ICH5.

This is on an Abit IC7-G with both the ICH5 and Si 3112 onboard, two Raptors in RAID 0 on each controller, all show up fine in textmode. I boot from the ICH5 and haven't tried booting from the Si 3112.

Share this post


Link to post
Share on other sites

Are you all using a sata hard drive?

Yes, I am. I slipstreamed the two drivers from motherboard_driver_raid_nvidia_ck804_bootdisk_xp.exe (for the Gigabyte K8N-SLI mobo). Windows setup will detect my hard drive, will format the drive and I can even get through the actual installation part (with the windows xp tip screens on the right hand side), but then at final reboot I get the Blue Screen of Death with several Stop errors.

Share this post


Link to post
Share on other sites

Using nlite1.0f I get constant reboot after install. Tried safe mode but, that fails as mup.sys is loading and the system reboots. This does not occur using 1.0rc8 at all, or if I do not integrate any drivers with 1.0f. Further, tried recovery console to no avail; the constant reboot occurrs integrating either the 6.85, or 6.86 nforce4. I do not use any of boogy's packs-all is done manually by me with nlite. I believe this may be due to some keyboard language implementation the system does not like between 1.0rc8 and 1.0f.

Share this post


Link to post
Share on other sites

I have the same problem in combination with RynVM 2.07a, Nlite 1.0Final and the drivers of my Promise Raid controller. In VMWare it works ok, but when installing my workstation I get a blank screen and the instand reboot.

When I use nLite 1.0 RC8 it work great.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...