aamkaachaar Posted October 10, 2009 Share Posted October 10, 2009 first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it F3 T>/2F3 2> Zspin down completeF3 2 > USpin up complteF3 2 > /1F3 1 > N1and it gave error and hanged therewhen turning off and back on the drive doesnt properly spin up it tries to initialize but doesnt and stops any suggestion it all happend after N1 command failure plz post some suggestion Link to comment Share on other sites More sharing options...
Twittwilly Posted October 12, 2009 Share Posted October 12, 2009 first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it F3 T>/2F3 2> Zspin down completeF3 2 > USpin up complteF3 2 > /1F3 1 > N1and it gave error and hanged therewhen turning off and back on the drive doesnt properly spin up it tries to initialize but doesnt and stops any suggestion it all happend after N1 command failure plz post some suggestionDid you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board? Link to comment Share on other sites More sharing options...
aamkaachaar Posted October 26, 2009 Author Share Posted October 26, 2009 first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it F3 T>/2F3 2> Zspin down completeF3 2 > USpin up complteF3 2 > /1F3 1 > N1and it gave error and hanged therewhen turning off and back on the drive doesnt properly spin up it tries to initialize but doesnt and stops any suggestion it all happend after N1 command failure plz post some suggestionDid you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board?yes i did complete tighten the screws ....but still it tries to spin and stop spins and stop ....doesnt spin up fully upto drive initialisation Link to comment Share on other sites More sharing options...
jaclaz Posted October 26, 2009 Share Posted October 26, 2009 Did you use a card between the contacts and PCB?Check this:http://www.msfn.org/board/solution-seagate...-page-2021.htmljaclaz Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now