aamkaachaar

Did you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board? yes i did complete tighten the screws ....but still it tries to spin and stop spins and stop ....doesnt spin up fully upto drive initialisation

first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it F3 T>/2 F3 2> Z spin down complete F3 2 > U Spin up complte F3 2 > /1 F3 1 > N1 and it gave error and hanged there when turning off and back on the drive doesnt properly spin up it tries to initialize but doesnt and stops any suggestion it all happend after N1 command failure plz post some suggestion