Seagate 500gb

[aamkaachaar]

first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it

F3 T>/2

F3 2> Z

spin down complete

F3 2 > U

Spin up complte

F3 2 > /1

F3 1 > N1

and it gave error and hanged there

when turning off and back on

the drive

doesnt properly spin up

it tries to initialize but doesnt and stops

any suggestion

it all happend after N1 command failure

plz post some suggestion

[Twittwilly]

first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it

F3 T>/2

F3 2> Z

spin down complete

F3 2 > U

Spin up complte

F3 2 > /1

F3 1 > N1

and it gave error and hanged there

when turning off and back on

the drive

doesnt properly spin up

it tries to initialize but doesnt and stops

any suggestion

it all happend after N1 command failure

plz post some suggestion

Did you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board?

[aamkaachaar]

first the drive was spinning well and as the drive was bricked i used the terminal techniq to restore it

F3 T>/2

F3 2> Z

spin down complete

F3 2 > U

Spin up complte

F3 2 > /1

F3 1 > N1

and it gave error and hanged there

when turning off and back on

the drive

doesnt properly spin up

it tries to initialize but doesnt and stops

any suggestion

it all happend after N1 command failure

plz post some suggestion

Did you completely tighten down the screws after removing the cardstock (or whatever you used) from the Hard Drive Circuit Board?

yes i did complete tighten the screws ....but still it tries to spin and stop spins and stop ....doesnt spin up fully upto drive initialisation

[jaclaz]

Did you use a card between the contacts and PCB?

Check this:

http://www.msfn.org/board/solution-seagate...-page-2021.html

jaclaz