Resetting nLlite back to square one?

[fredcdw]

Hello:

I did something while playing around with hotfix integration it seems. At one point I created a integrated SP3 unattended install disk for a Dell box that worked perfectly.

Now it is FUBARed.

All I did different was to add hotfixes to the project ISO and nLite seemed to accept them, however after text setup reboots the PC I get this error:

A write Operation was attempted on a volume after it was dismounted

After which it will re-boot. It does this over and over.

So what can I do to get this back to where it works like it did before?

Thanks

[newsposter]

nlite is intended to be used as a SINGLE PASS utility.

If you fubar an ISO, you MUST start over with a fresh, unmodified XP source.

If you need to update an existing ISO, you MUST start over with a fresh, unmodified XP source.

[fredcdw]

Perhaps I didn't say this right when I said I added hotfixes to the ISO. I mean that I added them in from the nLite program itself.

I will re-do the source files though, I just thought there would be an easier way.

BTW what do you mean by "single pass utility"?

[mara-]

BTW what do you mean by "single pass utility"?

I think that he meant that you should not use nLite more then once on same source, because most of the time that will cause some error. As already said, always you fresh, unmodified source.

Cheers

[Ponch]

To get it back to where it was before, restart from your original disk, then run nLite successively, loading the "Last sessions" in the same order you did before. Not the last one obviously.