Hi, i been attepting to have OpenCL and CUDA support on WinPE...

Cuda is tricky, AMD OpenCL is my priority, i have two problems;

1) I cant get msi installer to work

2) The VGA drivers are loaded with drvload, but i cant find a way to "enable" them, GPU-z still dont known what vga is installed, so Standart VGA driver is still used by PE.

Any ideas?

About .msi installer i managed to be able to start/stop msiserver service, but still says "windows installer service cant be accessed"

update: i think i discovered the problem with vga drivers, using devmanview i noticed it says "Display", instead of "Standart VGA device"... thats why loaded drivers cant "update" it... any way to workaround this?

Edited May 11, 201115 yr by shivan

Your installer should work with Make_PE3, but I've never gotten correct VGA drivers to work in PE.

I was able to load vga drivers perfectly on a older make pe version... i cant do it anymore in 4.0.

If i can avoid make pe the better, that means i need to first make a wim image with make pe and then load it again and use my batch to add stuff to it, but well if a dont have another option... still with make pe 4.0 i was unable to... i dont remember what version was the one that i managed to put up vga drivers from inside the winpe using drvload.

besides i dont need gui... i have batch files running on WinPE to run stuff on it from a remote computer.

Edited May 11, 201115 yr by shivan