ivanbuto Posted May 29, 2008 Posted May 29, 2008 Hi all,my older USB external hard disk is dying and I need to buy a new one to back up my data.The drive that I have now uses the standard USB mass storage driver (geneuide.inf). I am using Windows 98 SE.I am thinking about buying a 250GB or 320 GB drive, but all the major manufacturers (WD, Maxtor, Toshiba, etc.) don't list Windows 98 (SE) as a supported system.My question is: Do you think that it will be possible to use for example the WD "My Passport" with Win 98? Will I need to install the Maximus Decim USB drivers? Or perhaps I could use the Wintricks generic USB driver?http://www.westerndigital.com/en/products/...asp?DriveID=391I have also found a manufacturer that does support Windows 98, however their drives on the internet are somewhat more expensive:http://www.cavalrystorage.com/handheld.aspThanks for any advice.
Chozo4 Posted May 29, 2008 Posted May 29, 2008 (edited) It should work since it's just another mass storage device. However, although doubtful - you might end up with one formatted using NTFS which would mean a reformat into FAT32 but that could be the only real drawback.As far as listed as win98/etc compatible, most usb thumbdrives nowdays for example list win2k/xp as minimum but work 100%. A few aren't even listing win2k anymore for that matter but still work fine. So, should be the same for USB hard-drives.Only *cough*'real'*cough* requirement for an OS is due to the software that comes pre-loaded onto the drive which is often not used anyway. Such software may not be compatible such as the U3-Software on a [specific manufacturers] drive (junk anyway; loads on drive insert and takes forever to even load).Why not consider getting a Hard-Drive enclosure instead? This way if the drive dies you can easily open it up and swap out the hard drive itself. Also versatile as you can also swap it out for 'adapted' laptop drives or cd drives. Which even further makes it usable to swap-in an HD from another PC for drive cloning/imaging or even recovery.As for driver, your best bet would be Maximus-Decims USB drivers. From personal experience, they've yet to fail me. Your Mileage May Vary... Edited May 29, 2008 by Chozo4
niknak Posted May 29, 2008 Posted May 29, 2008 (edited) WD do appear to support this HDD in W98SE go here http://support.wdc.com/download/index.asp?...=18&swid=38 or if that is not the one try http://wdc.custhelp.com/cgi-bin/wdc.cfg/ph...amp;p_redirect=&p_lva=&p_sp=cF9zcmNoPTEmcF9zb3J0X2J5PSZwX2dyaWRzb3J0PSZwX3Jvd19jbnQ9MTcsMTcmcF9wcm9kcz0yMjgsMjA5LDIxMSZwX2NhdHM9MTIzJnBfcHY9My4yMTEmcF9jdj0xLjEyMyZwX3NlYXJjaF90eXBlPWFuc3dlcnMuc2VhcmNoX2ZubCZwX3BhZ2U9MSZwX3NlYXJjaF90ZXh0PTk4U0U*&p_li=&p_topview=1Sorry about the length of that link but it goes to their support page It appears there may also be a driver for W98 FE (Retail ver).Driver can be found here http://support.wdc.com/download/index.asp?...=18&swid=38HTH Edited May 29, 2008 by niknak
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now