Hi,

Would really appreciate assistance with routing between three lan segments. This has me knakkered...

Lan A = 192.168.0.0/28 with RIP1 routers on segment

Lan B = 192.168.1.0/28 with RIP1 routers on segment

ADSL Router 10.0.0.1/28 with NAT and firewalling and Wireless

Lan A has a Windows 2000 Server setup with RRAS doing lan routing between 192.168.0.0/28 and 10.0.0.0/28

IP=192.168.0.4/28 and IP=10.0.0.4/28

Lan B has a Windows 2003 Server setup with RRAS doing lan routing between 192.168.1.0/28 and 10.0.0.0/28

IP=192.168.1.4/28 and 10.0.0.7/28

Lan A can ping right into Lan B with good responses.

Lan B can't ping into Lan B (Yet ONLY the server can ping some devices. NOT ALL)

With pathping, traceroute or ping from behind the LAN B server, all ICMP replies simply terminate at the LAN A server.

RIP and OSPF is used on both servers.

When RRAS is enabled on LAN A all machines and sub branches can communicate right through to the I-Net and in between.

Yet, the moment LAN B's RRAS server is enabled, RIP kankkers up... (Equally if this action is reversed between the Lan's)

For some unknown reason to me, either of the servers create a 4.0.0.0/255.0.0.0 or 18.0.0.0/255.0.0.0 route entry on their near site adapters and RIP replicated this entry to all the other routers.

Any advice on how to sort this irritating issue will be greatly appreciated.

Thanks

StormRage

These really /28? 14 available IPs?

Can you post a network diagram?