Cutting boot disk using NERO6

[Railman5]

Hi. I have just created my first slipstreamed win 2k installation files with Service pack 4 and all the hot fixes in a SVC.inf pack. Went through the guide with a fine toothcomb and did everything by the guide. (up to the intermediate section and stopped).

Problem is when I try to copy the unattended folder structure using NERO6.

I have burnt disks via the CDROM (ISO) method and did the disk at once method and track at once as a guide showed!).

I tried CDROM (Boot) again using disk at once.

However when I tried using the disk in a newly formatted hard disk nothing hapens. it runs but wont even start to load any files.

Is there some setting I am not using or option to use. Which should I use?

I notice that I also have a folder (in mycase 2000CDdistribution?? This shouldn't be included should it?, as if so it goes way over a CD limit!

I have followed the eleder geeks guide to using NERO but they use a earlier version.

Help appreciated to where I am possibly going wrong as I am rapidly running out of CD disks!!

[Tbone2]

to cut down on size of the image you could try and delete the lang folder from the i386 folder....will still be able to install in english version....are you sure you have a good winxp boot image?

try open image in like winiso.....try VP and istall that way?

[Railman5]

OK

Thank you forv the advice.

That will cut about 64 meg from the installation.

Still not sure if I needed to merge the 2000distrib folder.

This came about when I was creating the answer file I think??