farkus Posted September 12, 2009 Share Posted September 12, 2009 I used nLite to slipstream SP3 onto a disc I had previously made with nlite that had SP2 on it. When I boot from the disc and begin the install process, I get the message 'Setup cannot copy the file xxx' immediately. If I skip it over, a few files will copy then I will get the message again and so on. If I make a new disc integrating drivers and other tweaks, but not SP3, then it works fine. Link to comment Share on other sites More sharing options...
johnhc Posted September 12, 2009 Share Posted September 12, 2009 farkus, running nLite against a source that has had nLite run against it before is asking for trouble and often leads to the kind of problems you have. Also it is unnecessary to apply SP3 and SP2. You should only apply SP3 and doing otherwise may lead to problems. So you need to start over with a fresh source. You can use your original Preset. And, please attach (not paste) your Last Session.ini. Make sure to always start with a fresh copy of your CD files/folders, do all your work in one nLite session and integrate only one SP. Please report when you have a solution, so others can benefit. Enjoy, John. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now