I tried a second install after correcting several problems and WPI opened (I had set options to Select None, so I could watch) and the wrong configuration file was selected. There was no Config button, so I had to close it and reopen it to get the buttons back. I changed the configuration to the one I wanted and ran it without any problems (real progress from the last time when WPI.hta could not be found). This wrong configuration problem seems to plague me. In Options-Installer I have my desired config (only) specified in the list of configs and have it selected in the 'Check on load' pull-down. There are several config files in the WPI Scripts folder.

Thanks for any help.

John

Edited April 27, 200818 yr by johnhc

It's actuallly defined using switches.

The info is in the changelog a few versions back just read through it.

It's like wpi.hta config=standard.js

Kelsenellenelvian, thanks for your rely.

I assume I should modify the following line in RunWPI.inf ($OEM$):

[Launch.WPI]

CMD /Q /C CD /D """%01%\..\WPI""" & START /WAIT /B WPI.hta

To something like:

CMD /Q /C CD /D """%01%\..\WPI""" & START /WAIT /B WPI.hta config=Pre_Complete_2.js

This is very important information and I think it belongs in a more obvious place than the change log (such as the manual).

Thanks again.

John