I've search the board and can't find any thing that applies to my situation. Maybe I'm not using the right words in my search, so forgive me if I'm bringing up something that is already been dicussed.

I have an image that I've made, I run sysprep, and upload it to a network share with BartPE and Ghost32.exe. We are a Dell shop so I have 1 image for laptop's that works with D400's through D620's. We just got the new D630's in and I've noticed that it uses new SATA drivers, so I've updated the BartPE disk with the new drivers but I'm at a loss how to add them into Windows. The install for the new drivers just extracts them into file as if one were going to put the drivers on a floppy and use the F6 method when doing a fresh install. I've tried setting the IDE controller to Standard and copying the INF files and into c:\windows\inf directory but with out success.

Again, sorry if I'm going over something that has already been covered in length.

you'll need to recreate your image and add the sata controllers to the massstorage section of your sysprep.inf.