Thanks to Seagate's utter incompetence and willingness to disregard their customers, I find myself here after finding my ST3500320AS is now completely bricked. I have studied this thread as thoroughly as I think I need to complete the fix, although with minimal electronics knowledge I have one main question. I am going to use the CA-42 cabling method as I have a few on hand that seem to be in working order, but my question comes in regards to the connection between the cable wires and the PCB. I have no soldering equipment so anything to do with that is not an option, are there some sort of jumpers I can purchase that will fit the PCB connection? What would the consequence be if the RX-TX wires accidently shorted during the terminal session? If someone could provide close up pictures of their cable wire to PCB connections it would be much appreciated. Are there any hints or tricks without the need of a soldering iron? I don't want the connections to drop out midway through the terminal session or at any stage of the process to be honest. Cheers in advance for anyone who provide help