Verify Raid / ATA 133 / ATA 100 / Driver Setup

[Spinman]

Would appreciate it if someone would verify my setup to see if I am on the right track:

Do I need to specify the particular driver (as I have done below) - or just specify the directory path where the drivers are?

Trying to add drivers for:

1)OnBoard Promise Raid 20276 Chip

2) Maxtor Ultra 100 PCI Controller Card (promise chips)

3) Maxtor Ultra 133 PCI Controller Card (promise chips)

To summarize in my particular case:

1) Add the following four lines to my winnt.sif file:

[scsi]

FastTrak133_xp = "WinXP Promise SBFastTrak133 Lite Controller", FastTrak

Ultra133TX2_xp = "WinXP Promise ULTRA133 TX2 Controller", Ultra

Ultra100_xp = "WinXP Promise ULTRA100 Controller", Ultra

2) Add the following two lines to my winnt.sif file:

[unattended]

OemPnPDriversPath="Drivers\PromiseRaid\Fasttrak.inf;Drivers\MaxtorUltra\ultra.inf;Drivers\Catalyst3_6\Video_DriverKXP_INF;Drivers\Catalyst3_6\TV_Capture\WDM_XP"

(Note: in the above - I've specified the specific inf driver for the 3 disk controllers - but not for the video and capture - I assume that I should remove the fasttrak.inf and ultra.inf portions...)

3) Added the following two files to the directory ~ c:\xpcd\$OEM$\$1\drivers\PromiseRaid\

FASTTRAK SYS Microsoft WindowsXP miniport driver

FASTTRAK INF Microsoft Windows miniport setup file

4) Added the following two files to the directory ~ c:\xpcd\$OEM$\$1\drivers\MaxtorUltra\

Ultra.sys

Ultra.inf

ultracoins.dll

(do I need the ultracoins.dll?)

Thanks -