SP2 & Sysprep now constantly rebooting

[Mr_Caine]

Just built and new PC image for work and having configured the beauty I ran the sysprep utility as per normal with the -quiet -reseal -mini setup with a fully automated sysprep.inf file, however it goes into a constant reboot requiring me to enter the username, organisation, product id and reboots at the point I would normally expect it to move onto the installing network components. I used the sysprep.exe from SP2 deploy tools. I wonder if there is a bug in the SP2 deploy tools

Anyone got some ideas how to resolve without going through the config all over again!

I hope this is the right forum.

[ms1974]

Hi,

Not sure if this will be any help, but I did notice this happening when I was sysprep'ing Compaq servers a while back. Turned out to be the teaming software for the network card. It needed to be disabled.

Bit of a long shot considering you probably don't have teaming installed for a workstation but maybe check the other network components you have installed for the workstation image.

Regards,

Mark

[TrAvELAr]

I answered this exact question yesterday. Search for it.