Mr_Caine Posted August 11, 2004 Share Posted August 11, 2004 Just built and new PC image for work and having configured the beauty I ran the sysprep utility as per normal with the -quiet -reseal -mini setup with a fully automated sysprep.inf file, however it goes into a constant reboot requiring me to enter the username, organisation, product id and reboots at the point I would normally expect it to move onto the installing network components. I used the sysprep.exe from SP2 deploy tools. I wonder if there is a bug in the SP2 deploy toolsAnyone got some ideas how to resolve without going through the config all over again!I hope this is the right forum. Link to comment Share on other sites More sharing options...
ms1974 Posted August 27, 2004 Share Posted August 27, 2004 Hi,Not sure if this will be any help, but I did notice this happening when I was sysprep'ing Compaq servers a while back. Turned out to be the teaming software for the network card. It needed to be disabled.Bit of a long shot considering you probably don't have teaming installed for a workstation but maybe check the other network components you have installed for the workstation image.Regards,Mark Link to comment Share on other sites More sharing options...
TrAvELAr Posted August 27, 2004 Share Posted August 27, 2004 I answered this exact question yesterday. Search for it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now