Installation differs from instructions

[fritzman]

Hi,

I just downloaded nLite ver 1.4.9.1. When I run the program, it runs as stated in the guides (http://www.nliteos.com/guide/) up until the end of the page of Part 1 of the guide. When I click on the "select" button to select my SP, the program starts the process of slip streaming. I do not get any of the options described in Part 2 and Part 3 of the guides, even though I've selected all but one of the options in the "task selection."

What am I doing wrong? What am I missing?

Thanks very much, in advance!

Fritzman

[johnhc]

fritzman, Welcome to the nLite forum. Well, what does it do? Normally, it takes a while for the SP to install, then it takes a while longer after the completion message before the Next button is available to click, then, you click Next and it goes to the following Task. Give us more information and we will try to figure out what is going on and, please attach (not paste) your Last Session.ini. Make sure to always start with a fresh copy of your CD files/folders, do all your work in one nLite session and integrate only one SP. Please report when you have a solution, so others can benefit. Enjoy, John.

[fritzman]

Thank you for your prompt response.

I figured I what I was doing wrong. Basically, I am an id***. I didn't read the message close enough. What I thought was completion of the entire process, was merely completion of the SP3 integration. All I have to do is click "next" to get to the following steps.

Sorry for wasting your time.

fritzman

[g-force]

In Germany it`s called "Einsicht ist der erste Weg zur Besserung".

Meaning is: To know yourself is the best way to improve!

So Good Luck, best wishes for your further nLitement, and THX for reply!

Edited April 13, 2009 by g-force