-
i have the following controller card: ultra 133tx2 i dont have the serial number bios/driver number from the disk: v1.01 20031009 pc system compaq presario 5000 66 MHz motherboard OS Windows xp pro sp2 intel celeron processor 598 MHz, 384MBs of RAM i have a compaq presario 5000 series (6 year old pc) that had a hard drive with a capacity of 15gb. i wanted to upgrade the hard drive to a 250 gig seagate hard drive and replace the old drive (wester digital). i purchased the controller card so i would have full capacity of the seagate hard drive instead of the 130gig that the motherboard will recognize. initially i installed the card incorrectly my first process: installed card in motherboard, boot up on old hard drive, and install drivers from within windows then install hard drive, run the diskwizard program to format and copy files over. after copying the files over i would then disconnect the original drive and boot from the seagate. this did not work because i didnt have the card setup as a boot option so i tried to repeat the process in the manual: install card and hard drive in the pc, attach new harddrive to pci card, boot up windows with cd or disk and install the drivers from the windows. when i tried the later process (after step 5 in the manual for setup on windows XP system) i received the error "\winxp/ultra.sys caused an unexpected error (1034 or 1036) at line 2108 in d: \xpclient\base\boot\setup\oemdisk.c." i also downloaded the drivers from the website and i received the same error message. if there's another process i can follow to successfully get windows xp to accept the drivers for the controller card i would greatly appreciate the help. thank you.