-
It should be read, as you indicated Jhothagondyaz Post # 1
-
Hello sanfran16to80, I explain: To mount the board you need to follow the following schedule: http://www.tdubel.com/artikkelit/tiedostot...ial_english.pdf (I did is the difference that are of 10uF capacitors instead of 0.1uF) To find the material you need and assemble approximately 1 days, especially if you are not electronic or left long ago. Once assembled, it is a matter of patience and time, about 2-3 hours (to recover disk clone) So with a little luck you have time. Greetings!
-
Hello! I have the same problem. HD: Seagate 7200.11 500Gb Firm: SD81 RS232/TTL: Handmade (I made it with ST232 using the unlocking guide ST310014ACE by cyd0g. The capacitors are 10uF (original 0.1uF)) Loopback test: Works fine! I can't tried separated the motor contacts or PCB off the drive. Ideas, please?. Thanks a lot!. PD: I'm thinking purchase Generic CA-42 Nokia cable. It's a good idea?. Have you cross the RX an TX lines? RX Hdd <-- TX cable TX Hdd <-- RX cable GND <-- GND What power supply do you use for the adapter? +5V from floppydisk's connector? Great!!!!!!... My hdd is back again to life!!!!! ohhh yeahhhhh!!! Pichi, my mistakes were told that, especially not connect GND. Thanks a lot Jhothagondyaz, Pichi and Gradius2 for your support.
-
Hello! I have the same problem. HD: Seagate 7200.11 500Gb Firm: SD81 RS232/TTL: Handmade (I made it with ST232 using the unlocking guide ST310014ACE by cyd0g. The capacitors are 10uF (original 0.1uF)) Loopback test: Works fine! I can't tried separated the motor contacts or PCB off the drive. Ideas, please?. Thanks a lot!. PD: I'm thinking purchase Generic CA-42 Nokia cable. It's a good idea?.