-
Yeah, I have separated the hard drive from the PCB by a piece of card as was suggested by someone. Also I have taken the PCB off the drive altogether. It's the same message on hyperterminal no matter what I do. I'm thinking there isn't much else i can try. The drive does appear to spin down after initial connection (using the card between the drive and PCB)) but that's obviously not controlled by the software. Thanks for the speedy reply aotta by the way.
-
I am unfortunate enough to have a Seagate hard drive. I have a 7200.11 with LC11 firmware. It became undetectable in the bios and of course xp around 2 week ago. I have followed the instructions, made up the cables etc but when I run HyperTerminal and type in control Z followed by /2 and then Z I don't get the SPIN DOWN message all I get is LED:0000000CC FAddr:0025BE0F. This scrolls down the screen about 1 line every minute and locks me out of the interface. Does anyone have a solution? Can anyone help?
-
I am unfortunate enough to have a Seagate hard drive. I have a 7200.11 with LC11 firmware. It became undetectable in the bios and of course xp around 2 week ago. I have followed the instructions, made up the cables etc but when I run HyperTerminal and type in control Z followed by /2 and then Z I don't get the SPIN DOWN message all I get is LED:0000000CC FAddr:0025BE0F. This scrolls down the screen about 1 line every minute and locks me out of the interface. Does anyone have a solution? Can anyone help?