Jump to content
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble

MSFN is made available via donations, subscriptions and advertising revenue. The use of ad-blocking software hurts the site. Please disable ad-blocking software or set an exception for MSFN. Alternatively, register and become a site sponsor/subscriber and ads will be disabled automatically. 


  • Content count

  • Donations

  • Joined

  • Last visited

Everything posted by Mikul

  1. Hello again Gradius2 I have managed to get control of the drive again in Hyperterminal, after reading the various posts again I realized that the cycling message is the result of the BSY problem, managed to go through it again and Hey Presto, IT's ALIVE. Just dragging off my photos for the last year and a half, about 30,000 of them. A massive massive thank you to you and all who have helped with this problem I could KISS YOU but I am far too manly for that kind of nonsense. Again thank you from the bottom of my heart, you have no idea how upset I have been over this!!!!!
  2. Hello Gradius2 Please can you help me? I think I have the seagate drive BSY problem. I have connected up a USB to RS232/TTL interface and got as far as spin down of the motor following your instructions exactly, all seemed to go ok until the step highlighted in red, then I could not get back to level 2 and I get this cycling message LED:000000CC FAddr:0025BF67 I have noticed on another thread http://www.msfn.org/board/index.php?showtopic=128807 It is done slightly differently, instead of CTRL+Z you just press U to spin the motor up. My drive seems inaccessible now, do you know of any way to access it to give me a second chance to retrieve my data? Thanks and regards Mikul On terminal press CTRL+Z: F3 T> F3 T>/2 F3 2>Z Spin Down Complete Elapsed Time 0.147 msecs F3 2> Wait 5sec and remove the paper card, this will connect the PCB to HDA (spin motor), but since is in Spin Down state (from cmd), you'll feel nothing. Now screw just enough to make a good contact between PCB and HDA (be real careful here, don't drop the screw, just be calm, relax!). Then press CTRL+Z again F3 2>U Spin Up Complete Elapsed Time 7.457 secs (if you get this msg you did everything fine until here) F3 2>/1 F3 1>N1 F3 1>/T F3 T> <<< At this step you'll need to POWER OFF your HD for 10sec, and then POWER ON again. By power off, remove the SATA power (not PCB!). When done, press CTRL+Z. F3 T> F3 T>i4,1,22 F3 T> F3 T>m0,2,2,,,,,22 <<< This command takes a little over a minute to complete! Max Wr Retries = 00, Max Rd Retries = 00, Max ECC T-Level = 14, Max Certify Rewrite Retries = 00C8 User Partition Format 5% complete, Zone 00, Pass 00, LBA 00004339, ErrCode 00000080, Elapsed Time 0 mins 05 secs User Partition Format Successful - Elapsed Time 0 mins 05 secs F3 T> You did it! Congratulations!