JohnnytheKid

oopers, you are correct. It is the 2.1.2 updates. I'm just a few zzzs short lately. I will try with the microwinx exclusion. Would you recommend excluding the VIA drivers to start off as well? thanks for such a quick response too. This place is on the ball. cheers

Hello. Just joined and have been reading through the forum but can't seem to find any answers I need. Here's my situation: I have downloaded and tested both v. 1.0.1 and 1.2. I got a test iso installed made with 1.0.1 ( on vmware) with RVMupdatepack 1.7 and all latest drivers downloaded from VIA's site (have a MKII 12000). I included XP SP2 and microwinx 2.5 pack and last session file as well and got it to boot no problem. I was excited to play with nlite 1.2 and ran a fresh setup with the same drivers and stuff listed above. Only, now, after installing it boots to a login screen. When i pun in the password and login. It immediately flashes a "saving settings" message and goes right back to the login prompt. I've been running fresh setups over and over and do not know what mistake I could be making. I'm leaving pretty much all the default settings as loaded by the microwinx file except for removing all drivers but vga filters and am running out of hair to pull out. I'm just a noob and have probably been making some little noobstake but any help or insight would be much appreciated. I'm so excited about Nlite that I'd hate to think it just wouldn't meet my needs. (car pc) thanks much and Nuhi is my new hero (right after James Dean).