kazimates
Content Type
Profiles
Forums
Events
Posts posted by kazimates
-
-
again agagain and again still same problem. what can you refer to me. thanks for your support...
0 -
do you have a list for commands and means or where can i find the command and means for seagate and other hdd's.
0 -
I tried with this procedures but it gives same message to me and they don't spin down hdd.
1- power on hdd with plastic card
2- open hyperterminal and adjust the parameters
3- press CTRL + Z
4- it shows F3 2>
5- type /2 and enter again
6- wait 1 min.s
7- type Z and enter again .
it gives LED:000000CE FAddr:00280481 message to me . i tried too much this procedures but they show message to me and they don't pass this message.
0 -
i have seagate ST3500320as AND İT İS barracuda 7200.11 and firmware is SD15. When I try to start this job it gives the error below after Z command. what is the problem at there?
F3 T>
F3 T>/2
F3 2>Z
LED:000000CE FAddr:00280481
LED:000000CE FAddr:00280481
LED:000000CE FAddr:00280481
LED:000000CE FAddr:00280481
and they don’t spin down the hdd.
0
The Solution for Seagate 7200.11 HDDs
in Hard Drive and Removable Media
Posted
the motor contacts (3 pin) is soldered directly to the board. it is connected properly. and i measure it with ohmmeter. its ok. then i put plastic material to the other contacts and screwe the pcb on hdd body. then i connect power and communication cable to power supply and rs232 port with converter. opened hyperterminal and turn on power supply.
type Ctrl + Z and it shows F3 T>
typed /2 and enter
it shows F3 2>
wait more than 30 second
type Z and press enter
it shows
LED:000000CE FAddr:00280481
LED:000000CE FAddr:00280481 and they don't stop the disk