Jump to content

Unchecked "Cameras and Camcorders" when making xp with nlite


KindHead

Recommended Posts

I used my original XP PRO SP2 cd with nlite to make a newer trimmed down version.

During the process under the (Compatibilty) menu, I unchecked the "Cameras and Camcorders" box.

Now, when I plug in my camera, the Scaner and Camera wizard doesn't pop up like it used to.

I have just finished installing a lot of other software on top of xp, and would like to avoid making a new XP cd and doing a clean install all over again.

Is there a way to add this component back on my computer?

Looking for any advice, thanks.

Link to comment
Share on other sites


Make sure your autoplay is set up properly. Right click on the camera and look at the autoplay tab. Use TweakUI to check the Autoplay options. Make sure the Windows Image Acquisition service isn't disabled (put it in auto if you connect the camera often). Attach your last session.ini

Link to comment
Share on other sites

I should add that I also unchecked that box in Compatibility and my S&C Wizard works fine. The compatibility box doesn't remove anything. Instead, it should warn you if you remove anything that interferes with operation of anything you have checked.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...