Jump to content

Adding Drivers to Recovery Environment


Lowcarb

Recommended Posts

I slip streamed SP1 into my Vista Business x86 and added AMD AHCI drivers.

I've checked the system that was create and vLite shows that the drivers were indeed added.

When I boot this disk the initial recovery environment though does not show my hard disk drive (raid using ahci driver). and it asks if I want to load drivers.

Shouldn't integrating those drivers with vLite have solved this for me? Is there something else I need to do to make the drivers active?

Thanks Lowcarb

Link to comment
Share on other sites


How do you boot into the Recovery?

I boot the slipstreamed install disk and then select "Repair your computer" from the 1st screen

vista-recovery2.jpg

Since I added the AHCI drivers to my slipstreamed SP1 disc I expected that it would be able to see my raid1 drive, but it does not see it unless I add drivers (the same drivers that I added with vLite).

vista-recovery3.jpg

then after adding ahci drivers I can see the Vista install that I want to repair.

I want to have a repair disk that requires a little intervention as possible.

Thanks, Lowcarb

Edited by Lowcarb
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...