Jump to content

How to Allow WPI to Reboot then Resume WPI?


Recommended Posts


With reading the manual and then using the %reboot% option that is built in.

So command2 would be %reboot% 30 (The 30 representing seconds to wait till rebooting)

Little warning though WPI will resume in that little "Dead" area of time between loggin on and loading the desktop so other than WPI running you will not be able to do much...

Link to comment
Share on other sites

Thanks for your reply, but I read the manual and it does not mention the reboot command and although I did see the reboot command in the program, I was unsure if it was able to resume the installation of the rest of my programs, Because I did a quick test with it and it did not resume WPI, but I will try it again.

Link to comment
Share on other sites

In fact it worked perfectly. Forgive me for my incompetence. As a quick test I had WPI execute an AutoIT Executable I made then used used the command 2 with the reboot option, then set another program to run and everything went perfect and as expected. Rebooted and resumed the install. Thanks again.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...