Pereldar

Done! Finally saved it! Ok, so, I did the regeration step, without the OFF/ON step, but nothing happened (I waited like 30 minutos just in case). Disconnected everything, and did all steps again (without the OFF/ON), but before the regeneration step I did the Skip G-List step, and that did the trick. Thank you very much!!

Close hyperterminal and start it again. CTRL+z, etc. should start a new session with the disk. jaclaz I've tried that too, but it doesn't respond to CTRL+Z. Could I skip the turn ON/OFF step, get back to test level prompt (/T) and do partition regeneration step ( F3 T>m0,2,2,0,0,0,0,22 (enter) )? What do you think? Thanks!

Hi! Here's Jose, from Spain. Fist time here. I'm another one with a f***ed up 7200.11 BSY drive. I've been trying this solution but I have a problem. I just can't get pass the Power ON/OFF step. Once I power it on again, hyperterminal quits responding. I'm using a CA-42 generic cable modified by me. It seems to work fine cause I can do the steps before the Power ON/OFF. I'm using Windows XP, and Hyperterminal, haven't tried putty. Any ideas? Thanks in advance!