Jump to content


  • Posts

  • Joined

  • Last visited

  • Donations

  • Country


Posts posted by CrazyDoctor

  1. Hi Peter,

    Thank you very much for your great help!

    I did the actions as you guied, but nothing happend.

    I connect all the wires (Which I hope that I did it right: The black wire is GND, the red is TX and the white is DX), and connect it to the terminal, but I don't see any respond (I connected sata power to the hard drive).

    Nothing happend when I hit the sequence Ctrl + Z (Somthing like F3 T> should appear after that but it didn't).

    I switch the wires for case that I plug it wrong but still nothing.

    I can't think about what I do wrong.

    Is the connector doesn't do its purpose?

    What can I do?

    Many Thank!!

  2. Hi Peter,

    Thank you very much for your help!

    I wish everyone would be like you! :)

    I plug 2 of the 3 wires that I have (whit- don't know what it is, Black - RX, Red- TX. Am I right?)

    I followd after the guid here:

    but the terminal does not respond.

    When I hit Ctrl + z does not appear on the scren the letters: "F3 T>m". is this the right sequence?

    It looks like nothing happen at all.

    What should I do?

    Many Thanks Peter and have a great weekend!

  3. Hi all,

    I have seagate hard disk 7200.11 with 0 lba problem.

    following few guides whic I find in the internet, I bought the nessecery as can be seen here:

    http://www.msfn.org/board/topic/128807- ... 0011-hdds/

    how and where do I connect the wires to the TTL adapter?

    see the pictures and please tell met whic pin should I connect with a wire.



    Many Thanks!!

  4. I have 2.5 external hdd which suddenly required a driver which I don't have.

    The device manager show a yellow question mark "USB Device".

    I don't have an access to my data.

    I've already tried to plug it in few other computers and of all them show the same symptom.

    I took out the hard drive from it enclosure but the pcb does not have an IDE or sata connection.

    The only connection that I can see is the mini usb port which is built on the pcb.

    I've tried diffrent mini usb cables and it gives the same symptom for all the them.

    Any suggestions?

    How can I fix that?

    Is there any driver which can solve the problem?

    Many Thanks!

  • Create New...