Yesterday morning when i connected my Seagete FreeAgent 500GB Desk to USB of Laptop it was not getting detected , on removing cable Light was still on.I removed power,restarted PC,connedted to other PC all failed.. I had valuable 200Gb of data in that..Since drive was in warranty bit relaxed but then realized ,they dont quarantee data... Now i opened the harddrive thinking that SATA-2 -USB converter could be burned ,so i can get SATA drive as freeagent has normal Desktop harddrive insisde that.But when i connected it my pc with SATA connector it wasnt detected. Now i was really scared of loosing all of my data as it had my valuable photographs they were on flickr but it was in low resol and only fraction of them h**p://www.flickr.com/photos/alokprasad Prob Angel or God came and told me search for more.i usually had tried some software but it was not detected in BIOS i was damm sure ,i have lost all data. Now suddenly it came Gradius Artticle of 7200.11 i thought i have stucked gold.. Mine Seagate Freeagent had contains 7200.11 SD81 ,i was not sure tha it was BSY or not but somewhere in post ppl said error in Firmware SD81. So it was BSY error. I have Successfull repaired thanks to Gradius and all. I followed This . http://www.mapleleafmountain.com/seagatebrick.html I made a TTL TO RS-232 Converer using MAX232CPE so i used power supply from harddrive 5V(RED) instead of 3.3V as max232cpe doesnt work at this low voltage.Since ground was same to harddrive power and Adapter i didnt needed to connect Jumper GND and Harddrive GND (BLACK).only TX and RX from jumper was needed. i Connected Adapter RX of TTL to TX of HD (JUMPER nearer to data/power cable) and TX adapter to RX HD (jumper away from SATA Poer/DATA cable)This is confusing terminology RX and TX but above worked for me. TO 34800 N 8 1 settings for hyperterminal,i first forget to put paper as i was trying to see prompt but it didnt appeared so Then i inserted Paper Card between Motor and PCB and blocked the contact ,i power ON, and after few seconds i recived LED:000000cc FAddr:0024A051 LED:000000cc FAddr:0024A051 LED:000000cc FAddr:0024A051 So far so good. Pressing CTRL+Z I Recieved prompt. F3 T> Now To stop drive, F3 T>/2 F3 2>Z Spin Down Complete Elapsed Time 0.147 Msecs Now i removed the paper card slowing to make contact between Motor and PCB. Afer that i entered, F3 2>/1 F3 1>N1 F3 1>/T and here i did mistake i entered F3 T>m0,2,2,,,,,22 (0=ZERO AND five continous , in middle with 22 at end) and i recieved no response for almost 30 mins i thought drive is dead now. But i removed Power from SATA Drive(PCB) while jumper still connected , reconnected and afer few seconds CTRL+Z showed prompt again i entered F3 T>m0,2,2,,,,,22 And after few seconds i recived magic spell.. ....User partition Format succsuful.. Here my point is,my harddrive was in warranty but there was no way to check that it had 7200.11 SD81 Untill i opened it as Seagate site was reporting this to be free from error. Just dont buy Seagate Freeagent anymore and trust seagate like their harddrive they are unrelilable. Agains thanks to All|||