Hello Fernando 1, Ive been trying to get my new Acer X3200 that uses nForce hard disk drivers to work with bartpe. Got them from pack 15.24. Ive gone round and round trying to add them by the SCSIAdapter folder. Tried DTS mass storage plugin. Havent gotten the drive to work yet. I even went and pulled all the variants you have listed, as well as a number of others, and rebuilt and tested BartPE a few dozen times now, lol. If I use a BartPE cd I will get a BSOD. Which is what i'd get with my original xp install discs. I made an nlite xp install using the IDE drivers from 15.24 and it worked like a charm. So I know its a matter of getting these drivers into bartpe effectively. I finally went and made a USB bartpe which allows me to load up and avoid the bsod, however the hard drive isnt listed in it / isnt seen. So again its the drivers. I was able to get the drivers installed using F6 off another USB drive, but ideally I want this to work all in BartPE. Long story short I have been unable to get the driver to work or integrate into bartpe. If you have any advice or can direct me to someone who's done this i'd be massively grateful and happiness abounds Thanks !